13.
Make sure that all parts are properly tightened before you use the treadmill.
Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt
(see page 21). To protect the floor or carpet, place a mat under the treadmill.
12. Attach the Latch Housing (30) to the Left Upright
(31) with two 3/4" Screws (2).
Make sure that
the large hole in the Latch Housing is on the
side shown. Do not overtighten the Screws.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin as
shown. Insert the pin into the Latch Housing
(30), and tighten the knob back onto the pin.
2
30
31
Large
Hole
12
Knob
Pin
Collar
Spring
10. Lower the Uprights (31, 36) as shown.
See the inset drawing. Position the Uprights (31,
36) so that the treadmill Frame (74) is centered
between the Uprights.
Firmly tighten the Frame Bolts (32) and then the
Upright Bolts (40) on each side of the treadmill.
Do not overtighten the Frame Bolts.
36
31, 36
32
74
74
31
View from Above
Side View
10
40
11. Attach the ground wire on the Upright Wire (28)
to the indicated hole in the Base (48) with a
Silver Ground Screw (27).
Press the indicated grommet into the Right
Upright (36).
Raise the Uprights (31, 36).
48
28
36
11
27
Ground
Wire
10
Grommet
