6
1.
Attach the Rear Stabilizer (35) to the Frame (1) with
two M10 x 75mm Carriage Bolts (58) and two M10
Nylon Locknuts (84).
Press the Stabilizer Endcaps (36) onto the Rear
Stabilizer (35) as shown.
2. Attach the Front Stabilizer (3) to the Frame (1) with
two M10 x 76mm Button Bolts (74), two M10 Split
Washers (78), two Concave Spacers (65), and two
M10 Nylon Locknuts (84).
Do not tighten the Nylon
Locknuts yet.
Thread two M10 x 60mm Button Screws (66) with two
M10 Split Washers (78) and two Concave Spacers
(65) through the Front Stabilizer (3) and into the
Frame (1).
Tighten the two M10 Nylon Locknuts
(84), and then tighten the Button Screws.
Orient a Wheel (28) so the four posts (see the inset
drawing) are facing away from the Front Stabilizer (3).
Attach the Wheel to the Front Stabilizer with an M8
Nylon Locknut (59). Next, press a Wheel Cover (29)
onto the posts on the Wheel.
Attach the other Wheel
(not shown) in the same way.
84
35
1
84
3
78
78
65
65
66
65
78 66
1
36
36
28
29
74
78
65
59
3. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire Harness (18) to
the Lower Wire Harness (38).
Carefully slide the Upright (2) onto the Frame (1).
Be
careful to avoid pinching the Wire Harnesses (18,
38).
Attach the Upright with four M8 x 19mm Patch
Screws (73) and four M8 Split Washers (79).
Do not
tighten the Patch Screws yet.
3
2
73
73
1
73
79
38
18
79
79
58
2
28
Posts
1
To make assembly easier, read the informa-
tion on page 5 before you begin assembling
the elliptical exerciser.
