8
2. Orient the dry side jet pack (A) as shown and place
it near the three holes in the Inflatable Liner (29).
Slide the Temperature Probe Gasket (46) over the
connector threads on the Temperature Probe
Assembly (30). Insert the wire (not shown) through
the
small
hole in the Inflatable Liner (29) and then
push the Temperature Probe Assembly into the hole.
Make sure that the threads on the connector are
pushed fully through the vinyl liner.
Firmly tighten
the Temperature Probe Nut (47) onto the connector
threads. Connect the wire from the Temperature
Probe to the receptacle on the dry side jet pack (A).
3. Move the dry side jet pack (A) against the wall of the
tub. Pull the two connectors on the dry side jet pack
through the large holes in the Inflatable Liner (29).
Slide a Wet Side Gasket (48) onto each connector.
Firmly tighten a Wet Side Nut (49) onto each con-
nector.
4. Position the wet side jet pack (B) as shown. Place
an O-ring (52) in the groove of each connector on
the wet side jet pack.
Make sure that the O-rings
are positioned securely in the grooves, as shown
in drawing 4A.
Attach the threaded collar on the right side (as seen
on drawing 4A) of the wet side jet pack (B) to the
corresponding connector on the dry side jet pack
(A). Attach the left side in the same manner.
Important: If the threaded collars are not fully
tightened, the spa will not function.
Position the Pillow (26) over the hole in the top of
the wet side jet pack (B). Push the fasteners on the
Pillow through the appropriate holes in the wet side
jet pack.
2
A
46
30
Small
Hole
Receptacle
47
9
29
3
A
29
48
48
49
9
Connectors
4
A
B
26
29
O-rings (52)
4A
O-rings (52)
Threaded Collar
View of Inside of Wet Side Jet Pack
