12
Using the Controls
Refer to the diagram above. The function of each
control is explained below:
Display Invert: Turns the Display 180°, allowing it to
be read from the inside or the outside of the spa.
Air Control 1: Determines the amount of air flowing
through the hydrotherapy jets labeled A (above). If the
control is turned counterclockwise, the amount of air
flowing through the jets will increase; if the control is
turned clockwise, the amount of air will decrease.
Air Control 2: Determines the amount of air flowing
through the hydrotherapy jets labeled B (above). If the
control is turned counterclockwise, the amount of air
flowing through the jets will increase; if the control is
turned clockwise, the amount of air will decrease.
Jet Button 1: Turns the spa jets labeled A (at the left)
on and off. If the button is pressed once, the jets will
run, providing gentle hydrotherapy. If the button is
pressed again, the jets will shut off.
Jet Button 2: Turns the spa jets labeled B (at the left)
on and off. If the button is pressed once, the jets will
run, providing gentle hydrotherapy. If the button is
pressed again, the jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
buttons on the console have not been pressed for
longer than twenty minutes, the automatic mode will
be activated. The automatic mode will filter the water
for one hour every six hours. The water will be heated
as required to maintain the set temperature and
returned to the spa through the jets labeled C (at the
left). Note: To keep the filter and heat cycles from
running, the power to the spa must be turned off.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting
of the water. The temperature can be set from 80°F
and 104°F. The water heats at about 6°F per hour
with the cover on. Use a medical or other accurate
thermometer to check the temperature of the water.
Note: The word “COOL” will appear in the console
display if the temperature of the water is more than
20°F cooler than the set temperature. When this hap-
pens, the heater will automatically activate to warm the
water. The word “ICE” will appear in the display if the
temperature drops below 40°F. If this happens, the
pump will automatically circulate the water and warm
the plumbing to keep the water from freezing.
l
ll
Air Control 2
Air Control 1
Display
Temperature
Buttons
Display
Invert Button
Light
Button
Jet
Button 1
Jet
Button 2
A
A
B
C
