12
Using the Controls
Refer to the diagram above. The function of each
control is explained below:
Temperature Buttons:
Control the temperature setting
of the water. The temperature can be set from 80°F to
104°F. The water heats at about 6°F per hour with the
cover on. Use a medical or other accurate thermome-
ter to check the temperature of the water.
To change the water temperature, push either the
temp up or temp down button until the desired tem-
perature is reached.
If the letters OH, FL, or Sn appear in the display, refer
to page 17.
Pump Button:
Turns the spa jets on and off. This is a
two-speed button. If the button is pressed once, the
spa jets will run at low speed, providing gentle
hydrotherapy. If the button is pressed twice, the spa
jets will run at high speed, providing moderate-pres-
sure hydrotherapy. If the button is pressed again, the
jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
water temperature is below the set temperature, the
water will be heated as required to maintain the set
temperature.
Note: To keep the filter and heat
cycles from running, the power to the spa must be
turned off.
Light Button:
Turns the underwater light on and off.
Air Controls:
Determine the amount of air flowing
through the spa jets. If a control is turned counter-
clockwise, the amount of air flowing through the jets
will increase; if a control is turned clockwise, the
amount of air will decrease. Test each of the air con-
trols to determine which jets are controlled by which
air control.
Air Controls
Temp
Down
Temp
Up
Pump
Button
Light
Button
Display
