14
The
Light Button
controls the light. To turn the light
on, press the light button. To turn the light off, press
the light button again.
The
Temperature Buttons
control the temperature set-
ting of the water. The temperature setting can be from
80°F to 104°F. The startup temperature is set at
100°F. The water heats at about 6°F per hour with the
cover on. Use a medical or other accurate thermome-
ter to check the temperature of the water.
To change the water temperature, press the tempera-
ture up or down button until the desired temperature
is reached. After three seconds, the console will auto-
matically display the last measured water tempera-
ture.
If the temperature sensors detect a drop below 40°F,
then pump 1 (and the heater if necessary
)
will auto-
matically activate to provide freeze protection. The
equipment will stay on until the sensors detect that
the spa temperature has risen to within 15°F of the
set temperature. Pump 2 and the blower will purge for
30 seconds to 2 minutes at the end of the freeze con-
dition.
The
Blower Button
turns the ten air injectors, labeled
5 in the small drawing on page 13, on and off.
Summary of Contents for PARADISE IMSB53940
Page 21: ...21 Notes...
