Chapter 2
Installation
18
1
Locate jumper
J3
on the module (behind the mode select rotary switch).
shows the location of the
J3
jumper.
2
Place a jumper on pins 1 and 2 to set the module for
Remote
control, or pins 2 and 3 to set
the module for
Local
control. See
.
Figure 2-2 J3
Settings for Local and Remote Control
Note:
The white triangle near the jumper pins on the module
indicates pin 1.
Setting Jumpers for 600
Ω
/Hi-Z Input Impedance Control
This procedure only applies to modules that have the analog audio input submodule:
SFS6803
+
AI
+
T and OP
+
SFS
+
AI
+
T.
Follow this procedure to select an analog impedance of
600
Ω
or
Hi-Z
on each channel:
1
Locate jumpers CH1A, CH1B, CH2A, CH2B, CH3A, CH3B, CH4A, and CH4B on the analog
audio input module.
shows the location of these jumpers.
Figure 2-3
Impedance Jumpers on Analog Audio Input Submodule
2
Place a jumper on pins 1 and 2 to set the module for
600
Ω
input, or pins 2 and 3 to set the
module for Hi-Z
Do this for all eight channel jumpers.
Remote control
setting
Local control
setting
3 2 1
3 2 1
Impedance jumpers
CH1A-CH 4B
Summary of Contents for Selenio 6800 SFS6803+OP+SFS+
