Selenio
TM
BNP User Guide, Release 3.7.1
222
- DVB-CA Configuration
Configuring DVB-CA: External and Internal EIS Mode
Use steps in this section to configure DVB-CA for external and internal EIS modes. For internal EIS
mode, please include the additional steps provided in “Configuring DVB-CA for Internal EIS Mode” on
page 230 to complete that configuration.
The tasks for this configuration are provided in the following topics:
•
“Step 1, Create CA System” on page 223
•
“Step 2, Create ECMG” on page 223
.
•
“Step 3, Create EMMG” on page 225
.
•
“Step 4, Create EMM” on page 225
•
“Step 5, Join TS to EMM” on page 226
.
•
“Step 6, Verify Scrambling” on page 228
EMM Multicast IP
Specifies the multicast IP address on which
Ethernet Port 2 will receive EMM packets.
• Enter a valid multicast IP address in this field to
enable Ethernet Port 2 for receiving EMM
packets.
• Enter all 0’s (or leave field at the default of all
0’s) to not send EMM traffic via Ethernet Port 2.
Common to both
Update Timer (secs)
Specifies the amount of time (in seconds) before
the BNP should begin to transmit video services
in order to allow for encryption processing.
• Default is
0.
• The higher the number, the longer it will take
the end user to receive a video signal. If the
number is too low, programming will be
transmitted in the clear until the encryption
engine takes over. The recommendation is to
choose a number that will be an acceptable
level of delay for the end user while still
providing the minimum amount of clear data
transmission.
Common to both
Table 94.
DVB-CA Global Configuration fields (Continued)
Field
Description
Internal EIS mode or
External EIS mode
