Selenio
TM
BNP User Guide, Release 3.7.1
116
- Grooming - Mapping
3.
Click
OK
to save your settings and to place the new transport stream in the
Outputs
panel of the
Grooming
-->
Mapping
tab screen, beneath the selected GigE port.
Table 64.
Create Output Transport Stream Dialog Parameters (GigE)—MPEG-2 or SCTE
Field
Description
Port
This is read-only and is used for identification purposes.
SPTS
Check if the output is a single program transport stream (SPTS).
Non-DPI
Check this box if the transport stream is to use a Grooming-only (Non-DPI)
license.
TS Name
The (optional) name you want to assign to this output transport stream.
Multicast
Check if the output is for multicast operation.
Bitrate (Mbps)
The bitrate at which the stream is transported.
Multicast/Unicast IP
The IP address to which the output stream is routed.
• If
Multicast
is checked, this must be a valid multicast IP address.
• If
Multicast
is unchecked, this must be a valid unicast IP address. See also
Reserved Bandwidth (Mbps)
Enter any bandwidth value to be reserved from the total bitrate of transport
stream.
UDP Port
Enter the UDP port to use for transmitting data.
Unique TS ID
Allows you to assign a unique numeric ID to this transport stream.
• When this option is
checked
, the TS ID value placed in this field will be
reserved as unique for the entire chassis.
• When this option is
unchecked
, a TS ID value may still be entered,
however the value may be the same as another TS ID as long as that TS
ID’s value has not been reserved as a Unique TS ID.
• Note that each TSID is a unique number used to identify a transport
stream. It is a partition of two 16-bit hex numbers. The lower 16 bits (user-
specified in decimal and converted to hex) is the MPEG transport stream
ID. The upper 16 bits (0x) is strictly used internally.
• Default value is “
1
” if no value is specified.
• Broadcasters must configure this value with a unique ID to meet FCC
standards.
Subnet Mask
For unicast (Multicast unchecked), enter the subnet mask IP for the unicast
IP address entered in the
Destination IP
field.
Network PID
Decimal value to define the program ID of transport stream packets which
contain the network information table.
Note that display of this entry, in applicable screens, is dependent on the
current setting—as either hexadecimal or decimal—for
Configuration
--
>
Global PID Display.
ARP
If Multicast is checked, this field is
hidden
.
If Multicast is unchecked, this box will appear. Un-checking this box will allow
you to disable the use of Address Resolution Protocol (ARP) and to manually
specify a MAC address. See also
TS Type
The type of stream. The type of stream you choose determines what other
information is required. Choices are:
MPEG-2, ATSC, SCTE
, or
DVB.
