Selenio
TM
BNP User Guide, Release 3.7.1
177
- Managing PMT and ES Descriptors
Managing PMT and ES Descriptors
The
Element Manager
provides the ability to create program descriptor rules that the BNP will apply
when it sends out a Program Management Table (PMT) for a specified output program. The rules allow
for the appending or removal of output stream descriptors on the PMT level and will remain persistent
upon program regrooming.
Use the
Manage Descriptor Rules
screen (
) to view, add, edit, and delete program
descriptor rules.
Menu Path
From the
Outputs panel
of the
Grooming -> Mapping
tab screen, right-click on a
program and select
Manage Descriptor Rules
from the pop-up menu.
Figure 125. Manage Descriptor Rules window
The
Manage Descriptor Rules
screen displays details about currently configured rules. Details about
operations you can perform from this screen are described in the following topics:
•
“Adding Program Descriptor Rules,” next.
•
“Editing Program Descriptor Rules” on page 180.
•
“Deleting Program Descriptor Rules” on page 181.
Adding Program Descriptor Rules
Use the
Add Descriptor Rule
dialog (
) to set parameters for a new descriptor rule. A new
descriptor rule is not applied at the BNP until all steps in this procedure are completed.
Menu Path
Manage Descriptor Rule
screen: click
Add Rule
-->
Add Descriptor Rule
dialog.
