Selenio
TM
BNP User Guide, Release 3.7.1
43
- Ethernet Control Port Configuration
Ethernet Control Port Configuration
There are two Ethernet control ports for each BNP: one for basic management and access to the
Element Manager
. On the BNP 3xr, the other port is used for DVB-CA connectivity and access.
Use the
Ethernet Control Port
tab screen (
and
) to view and configure BNP Ethernet
control ports.
Menu Path
From the
Element Manager
tabs, select
Configuration -> Ethernet Control Port
.
1.
At the
Ethernet Control Port
tab screen, enter and/or type Ethernet control port values. Use the
following guidelines for IP addressing of these ports:
-
The IP address for Ethernet port 1 must be on a different subnet from any of the Gigabit
Ethernet IP addresses.
-
The IP address for Ethernet port 2 must be on a different subnet from the IP address of
Ethernet port 1, and any of the Gigabit Ethernet IP addresses.
2.
Click
Apply Configuration
to save and load the settings.
You can view the current Ethernet control port configuration either at
Ethernet Control Port
tab
screen, or at the
Chassis
tab screen.
Figure 19.
Ethernet Control Port configuration
