Selenio
TM
BNP User Guide, Release 3.7.1
99
- Configuring GigE Ports for Heartbeat Detection
Figure 50.
BNP Redundancy via Direct Connection
Eth0 10/100
BNP - Standby
GigE 1
GigE 2
GigE 3
GigE 4
GigE 5
GigE 6
GigE 7
GigE 8
Port
IP
Eth0 10/100
BNP - Active
GigE 1
GigE 2
GigE 3
GigE 4
GigE 5
GigE 6
GigE 7
GigE 8
Port
IP
Crossover
Cable
Virtual IP
Mgmt IP of Active
Mgmt IP of Standby
Web Browser
Configuration
• Autonegotiation =
Off
.
• IP Address for 10/100 = Mgmt IP address
of
active
BNP.
• Virtual IP Address =
none
(blank).
• IP Address for GigE port =
Port IP of GigE 8 of the
active
BNP.
Configuration
• Autonegotiation =
Off
.
• IP Address for 10/100 = Mgmt IP address
of
standby
BNP.
• Virtual IP Address =
none
(blank).
• IP Address for GigE port =
Port IP of GigE 8 of the
standby
BNP.
This configuration will ensure that the active and standby BNPs may continue to listen for heartbeats if
their management ports can no longer detect heartbeats over a faulty IP connection.
Use the following information and steps to set up a heartbeat configuration using cable-to-cable
(cross-over) connection between the GigE8 ports of the active BNP and the standby BNP.
•
“Prerequisites,” next.
•
“Configuring the Active BNP” on page 100.
•
“Configuring the Standby BNP” on page 101.
Prerequisites
The following assumptions apply to this configuration:
•
The active and standby BNPs are configured with IP addresses at their management ports.
•
The active and standby BNPs are running on the same IP subnet.
•
A cross-over cable physically connects the active BNP and the standby BNP at their GigE ports.
