Selenio
TM
VMG-14+ Hardware Setup Guide
55
Using TCON (Temporary Console) to Set Initial Configuration
Gen2 Release 1.4.0
Setting
Network
Addresses
for
the
NPM
To set the network addresses for the NPM, select
2
from the TCON main menu. Output similar to the
following example will be displayed.
Enter number of your choice: 2
Enter the mgmt interface IP address, netmask, gateway address, and DNS
address
Format is a single line of 4 dotted quads, for example:
10.0.0.34
255.255.255.0
10.0.0.1
0.0.0.0
Hint: use 0.0.0.0 for DNS when none is available
values:
(At the values: line, enter the single line of four dotted quads for your configuration. Using values
from the example Configuration of Mgmt Interface, this entry would look like the following):
10.32.144.240 255.255.255.0 10.32.144.1 10.32.11.11
Enter values for each installed NPM in the VMG-14+ system.
Verifying
Gateway
Connectivity
To verify connectivity with the default router (gateway), select
3
from the TCON main menu. Output
similar to the following example will be displayed, where connectivity is enabled.
Enter number of your choice: 3
Pinging 10.32.144.1
--------------------------------------------------------------------
PING 10.32.144.1 (10.32.144.1): 56 data bytes
64 bytes from 10.32.144.1: seq=0 ttl=255 time=2.6 ms
--- 10.32.144.1 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet los
round-trip min/avg/max = 2.6/2.6/2.6 ms
--------------------------------------------------------------------
** Connectivity OK
If connectivity is not enabled, a screen similar to the following example will be displayed.
Enter number of your choice: 3
Pinging 10.32.144.1
--------------------------------------------------------------------
PING 10.32.144.1 (10.32.144.1): 56 data bytes
--- 10.32.144.1 ping statistics ---
1 packets transmitted, 0 packets received, 100% packet loss
--------------------------------------------------------------------
** Have a connectivity problem
