Selenio
TM
VMG-14+ Hardware Setup Guide
81
Declarations of Conformity
Declarations
of
Conformity
Declarations of conformity pertinent to the VMG-14+ are provided in the following sections:
•
next.
•
.
•
•
.
•
“Australia/New Zealand” on page 84
.
United
States
Declaration
of
Conformity
Responsible Party Name: Imagine Communications Corp.
Address:
390 West Java Drive
Sunnyvale, CA 94089, U.S.A.
Telephone:
(877) 742-6389
Declares that product:
Video Multiprocessing Gateway—VMG-14+
Complies with Part 15 of the FCC Rules.
This device complies with Subpart B of Part 15 of FCC Rules for Class A digital devices. Operations are
subject to the following two conditions: (1) This device must not be allowed to cause harmful
interference; (2) This device must accept any interference received, including interference that may
cause undesired operation.
Modifying the equipment without Imagine Communications’ authorization may result in the
equipment no longer complying with FCC requirements for Subpart B of Part 15 of FCC Rules for Class
A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC
regulations, and you may be required to correct any interference to radio or television communications
at your own expense.
For
Class
A
Equipment
Note:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Canada
This Class A digital apparatus complies with Industry Canada Interference Causing Equipment Standard
ICES-003, “Information Technology Equipment (ITE)—Limits and methods of measurement”, Issue 5,
dated August 2012 (Class A).
