22
HDX6800
+
B2/C2 and HDX6800
+
B4/C4 Installation and Operation Manual
Chapter 2: Installation
Manually Adding a Device to the Discovery or Network Folder
If your device is not listed in the
Discovery
or
Network
folder, you
must manually add it to these folders. After you add the device, you can
use the
Software Upgrade
dialog box to continue with the module
firmware upgrade.
To manually add a device to the
Discovery
or
Network
folder, follow
these steps:
1. Enter Build mode, and then drag or copy and paste the module’s
device icon from the
Catalog
folder into the
Network
or
Discovery
folder.
2. Right-click the device icon, and then select
Properties
.
3. On the
Device
tab of the
Navigation Properties
box, enter the IP
address of the frame that holds the module. (See
Figure 2-6.
Navigation Properties Box
If you make changes in the last field (located above and to the right of
the Set Default button), you may lose your connection to the module. If
this happens, you will need to rediscover the module.
Do not make changes in
this field
Enter frame IP address here
Frame number=0
Slot number=17
Must be set to 1
