background image

Electrical Data: 
 

Supply voltage                                    

100-240VAC ; 50-60Hz 

              Current draw                                          

0.4 A maximum 

 

Power consumption                             

40 watts maximum   

 

Operating frequency                                        13.56 MHz    

 

      13.56 MHz 

              Transmission power                                         6 watts  
 

Interface  

                

 

RS-232 

 
 

Antenna power                                                                                                 6 watts maximum  

 

Antenna connection                                                       

 

      SMA plug (50 

 Antenna 

width

            

           

0.

37

 m (

14.6

 in.) 

 
 

 

 

 

 

7

Environmental Conditions: 
 

Operating temperature                       

 

-20° C to +55° C (  -4° F to +130° F)   

 

Storage temperature  

                

 

-25° C to +85° C (-10° F to +185° F)         

 

Humidity                                              

 

5%-80%, no condensation            

 

 

 

Applicable Standards 

 RF 

Approval 

  USA 

    FCC 

47 

CFR 

Part 

15 

 

 

Canada                                                            RSS-210

 

  Europe 

    EN 

300 

330 

 
 EMC 

     EN 

301 

489 

 
 Safety 
 

         Low voltage directive             

 

EN 60950 

                       Human Exposure                       

 

EN 50364 

 

 
 

 

FCC ID:  PB4DGSCN100

Operation is subject to the following two conditions:  (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, including interference that 

may cause undesired operation.

 

 
 

 

Modifying this device may void the user’s authority to operate the device

.

 

 

CANADA

 

This device has been tested and found to comply with the limits for a Class A digital device, pursuant 
to part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against 
harmful interference when the equipment is operated in a commercial environment.  This equipment 
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance 
with the instruction manual, may cause harmful interference to radio communications.  Operation of 
this equipment in a residential area is likely to cause harmful interference in which case the user will 
be required to correct the interference at his own expense.

  

USA

IC:  6900A-DGSCN100

 

 

 

Antenna cable length 

 

 

 

 

 

      0.9 m (36 in.) 

 Antenna 

length

            

          

0.

5

 m (

19.6

 in.) 

Summary of Contents for DataGuard rf Scan Station









Reviews: