9
ENGLISH
I
NSTALLING THE
DVD W
RITER
This chapter explains how to physically install your DVD Writer in your
computer. The steps you will need to do are as follows:
1.
Turn off your computer system and unplug from power outlet.
2.
Remove the computer cover.
3. Set the Master/Slave jumper on the rear panel of the DVD Writer.
(To get the best operation results of your Hard Disk Drive and the DVD
Writer, we strongly suggest you connection the DVD Writer to the
Secondary
IDE port as the
MASTER
device.)
◆
IDE Drive Configurations:
(A)
Hard Disk connected as Master device on the Primary IDE port; nothing connected
to the Secondary IDE port.
Set the DVD Writer’s jumper to
MASTER
, and connect the DVD Writer as Master
to the Secondary IDE port.
