8
6、Operating instructions
6.1. Preparation before operation
√ the machine head shall be in the stop state during the inspection by the
operator
√
Check whether the table sponge is intact
√ Check whether the sewing thread has been correctly put on
√ Check whether the needle has been installed
√ Clean the sundries on the machine table to ensure that there are no sundries
hindering the operation of the machine
√ Check the pressure of the barometer to make it meet the requirements of
the machine
6.2. Operation process description
6.2.1 Boot device
4.1-（1）Press the power switch to 1, and the equipment is powered on and ventilated.
6.2.2 Sewing
Step back on the 4.1 - (2) pedal, lift the presser foot, place the cloth according to
the garment process, step forward on the pedal, slowly speed up, move the cloth, sew until
the thread cutting is completed, quickly place the cloth on the flap, release the pedal,
and the cloth will be automatically placed in the discharge box.
6.2.3 Shutdown
After the operation, press the 4.1 - (1) power switch until the 0,device is shut down.
Summary of Contents for MB2002B-BS-FT7010
Page 3: ...ENGLISH...
