8
5、Operating instructions
5.1. Preparation before operation
√
When the operator checks, the machine head should be in the stop state
√
Check whether the pressure plate sponge is intact
√
Check whether the sewing thread is properly put on
√
Check whether the needle has been installed
√
Clean up the debris on the machine table to ensure that there will be no debris
obstructing the operation of the machine
√
Check the pressure of the barometer to make it meet the requirements of the machine
√
Check that the eye guard is properly installed
5.2. Operation process description
5.2.1 Start the device
When the power switch on button is pressed, the device is powered on。
5.2.2 Fabric position
Put the rolling strip into the rolling strip disc, fix the left and right locating blocks
of the lining ring with the hand nut, and then place one end of the rolling strip along
the material retaining rod，As shown in the following figure (a), finally put it into the
folder, as shown in the following figure (b): put the fabric into the folder, as shown in
the following figure (c)；
a
b
c
Locating
blocks
Summary of Contents for MB8024A
Page 3: ...ENGLISH...
Page 10: ...6 a Automatic cutting interface b Non automatic cutting interface...
Page 16: ...12 7 Electrical wiring...
