19.
Place the shift yoke & cam assembly [2
-
28] into the clutch cone groove with the nuts facing
down.
20.
Insert the shift link [2
-
24] with shift cable retainer [2
-
21] through front of gear case.
21.
From the rear of gear case, place the small hole of the shift arm [2
-
22] onto the
“
pin
”
of the
shift link and secure with cotter pin [2
-
23]. (Be sure that the shift arm is positioned to except
the detent kit [1
-
31].
22.
Install shift shaft [2
-
26] through the yoke & cam (note: use caution while installing to avoid cut-
ting seals) and shift arm [2
-
22].
23.
Torque the 2 shift shaft screws [2
-
27] to 100 in/lbs. Use
“
Loctite
262”
on screws.
24.
Install quad ring [1
-
10] steering cap [1
-
2] including detent kit [1
-
31], insure
“
O
”
rings [1
-
29 & 1
-
30] are in place.
25.
Torque steering cap screws to 35 ft/lbs. Use
“
Perfect Seal
”
on threads.
26.
Install quad ring [1
-
12] in steering cap, shift shaft plug [1
-
9], top cap
“
O
”
ring [1
-
13] top cap oil
pressure
“
O
”
ring [1
-
14]
27.
Install top cap.
28.
Torque top cap screws [1
-
8] (Important: short screws in 2 front & 2 rear holes [1
-
7] longer
screws in 2 port and 2 starboard holes) to 25 ft/lbs. Use
“
Perfect Seal
”
on threads.
29.
Install oil tank cover [1
-
43], oil tank gasket [1
-
42] with
“
Permatex Form
-
Gasket
2’
(note: use a
very thin layer on gasket), oil tank cover screws [1
-
41] with
“
Loctite
242”,
torque to 10 ft/lbs.
UPPER GEAR CASE
-
ASSEMBLY
Page 7
Summary of Contents for Xtreme Advantage SCX
