Attachment with screws, with external connections
If your ELOC3 has external connectors, you will need
to drill an additional 10 mm diameter hole in the
target surface. Before attaching the device, make
sure that the mounting surface is clean and without
any irregularities. Remove burrs and sharp edges to
avoid damaging the insulation of the cables. When
installing the unit, follow the instructions and notes
in the previous example (Attachment with screws,
no external connections).
Note, that the device may be exposed to high mechanical loads. For the highest
possible stability, the use of washers and crown rings, is recommended.
21 / 33
www.ime.de
