E211101X_rev02_ENG
29/06/2022
30
-
LOAD SYSTEM ICONS FROM USB: allows you to load new custom system icons through a special USB
interface.
-
MACHINE ON: allows you to manage the warning of the machine on when no ironing activity is in progress.
-
PEDALS: allows you to manage the functionality of the pedalboard (if any)
-
TEMP./VEL COMPENSATION: allows you to activate or deactivate the speed compensation according to the
temperature reached.
-
MAX COMPENSATION %: defines in value % the compensation TEMP./VEL.
Entering inside REGISTRATIONS you can check the diagnostics of the machine:
-
WORKING HOURS: the total working hours of the machinery can be verified.
-
PROGRAM STATISTICS: you can check the total number of programs performed and the repetitions of each
individual program.
-
DOWNLOAD RECORDINGS: you can download on usb the entire content of the recording’s menu.
-
ENERGY STATISTICS: It is possible to consult the consumption of electricity referred to the last ironing cycle,
referring to the entire working day and referring to the total.
34.
CALENDER MAINTENANCE
ATTENTION!
There is a risk of injuring yourself or damaging the equipment. Any ordinary or extraordinary maintenance
must be conducted by professionally qualified personnel. Make sure all power supplies are disconnected before
performing any type of maintenance.
Lock the interlocked switch.
For cleaning do not spray water or steam.
Ordinary and extraordinary maintenance are reported to follow with the expected cadences.
Do not allow the accumulation of threads around the machinery.
For daily cleaning use a soft, moistened cloth. Do not use abrasive products, abrasive sponges, solvents, or metal
objects.
EVERY DAY:
Remove any dust or fabric residues that may have settled on the temperature probe holder, to maintain good contact
between the support plate and the surface of the ironing roller.
Eliminate any residues of dust or fabric that may have settled on the side and rear filters to maintain a free passage of air
inside the carpentry of the machine.
Perform the same cleaning operation on all metal detachers.
The operation must be conducted, slightly lifting the detachers, one by one, and freeing them from the dust deposits that
can be deposited between the detacher itself and the surface of the ironing roller.
-
EVERY MONTH:
Perform the cleaning of the fans for the extraction of moist air and fumes (the latter only if present), eliminating all the
deposits that may form there.
Keep all moving mechanical parts lubricated (sprockets, bearings, side satellite bearings).
The gearbox is permanently lubricated and therefore does not require maintenance.
-
EVERY THREE MONTHS:
Proceed to clean the inner surface of the ironing roller by eliminating any dust residues.
