E211101X_rev02_ENG
29/06/2022
31
Check that the outer surface of the roller has not been corroded, worn out and that there are no melted parts of glued
fabric.
-
EVERY SIX MONTHS:
The bearings should be strengthened and, if necessary, greased.
-
TENSIONING AND REPLACEMENT OF INTRODUCTION BANDS (if necessary):
To tension the introducing bands act on the position of the introduction table. The table is fixed by two b-screws at its
ends.
To tension the introduction bands, loosen the two b-roller screws (see figure), change the position of the introduction
table (pushing it forward), and finally close the two Allen screws. Disassemble the introduction and collection slides.
To replace the introducing bands, proceed to the elimination of the existing ones. Remove the cover-basin element to
facilitate access. Insert the introduction bands between the separation pins under the introduction table. Close the bands,
with the proper Nomex wire, above the introduction roller.
Pinch one of the metal hooks at the end of the band to prevent the Nomex wire from slipping off. Remember to insert
the bands in the correct direction and direction (weaving in Nomex outwards and cutting at 45 ° downwards). Tension
the introduction bands as described above.
-
TENSIONING AND REPLACEMENT OF IRONING BANDS (if necessary):
To tension the ironing bands in Nomex open the two side shoulders of the machine and screw the pins connected to the
draft eyelet of the bands. Act symmetrically on the er inside the right shoulder and on the one inside the left shoulder so
that the draft of the ironing bands is uniform.
