EN
81
EN
80
• Identify a small area that is to be treated.
• Shave the area that is to be treated.
• After having set the lowest power level, apply the handpiece to the area
and emit the first pulse. If no discomfort is felt, increase the power to the
next level, move the handpiece to the adjacent skin area and emit another
pulse. Increase the power level on each subsequent area of skin until the
maximum tolerable level for the skin type. A feeling of heat can be felt on
the skin during the treatment, and this is normal. If discomfort is felt, the
maximum tolerable power level is the previous one.
• Check the area after 24 hours: if the redness persists, the maximum
tolerable power level for your skin type is the previous one.
Even though it is extremely rare, if hypersensitivity should persist for over
hours, it is recommended to consult a doctor.
ATTENTION: the power output directly affects the result, however, due to the
principle of heat of the treatment, the maximum limit tolerated by your skin
must not be exceeded. This limit is normally high for fair skin and low for dark
skin because melanin that darkens the skin increases the production of heat.
Do not exceed the maximum limit that your skin tolerates with no discomfort
whatsoever.
PREPARING THE AREAS THAT ARE TO BE TREATED
• The skin must be shaved, clean, dry, with no make-up, anti-perspirant
or deodorant.
• Moles, birthmarks, dark spots, tattoos and lips must be covered with a
white pencil or white patches.
ATTENTION:
Before starting the treatment, read the paragraphs relative to safety warnings,
contraindications, precautions for safe use, possible side effects, treatment
areas and hair removal program.
USE
pREpARING THE AppLIANCE
1. Remove the handpiece and the other components from the package.
2. Verify that the lamp (5 or 15) is inserted correctly into the appliance.
3. If the appliance is stored in a very cold place, wait for it to reach at least
15°C.
4. If the plug has not been inserted into the adaptor (14),
hold the latter, pull the “Open” key downwards and
insert the plug (14A, 14B or 14C), which is suitable for
the socket of the electrical system, into the relative slot.
5. Insert the adaptor cable (14) into the power supply
connection (4).
6. Insert the adaptor (14) in a socket: the stand-by LED lights up (9).
TREATMENT
7. Press the switch-on/stand-by button (10): the switch-on LED (11) lights
up and the ventilation system is activated (the noise is similar to that of
a hair dryer).
8. About 3.5 seconds after having pressed the switch-on/stand-by button
(10), the switch-on LED (11) lights up: the appliance is automatically set
to the lowest power level.
O P E N
Summary of Contents for Bellissima Flash&Go Plus 120.000
Page 63: ......
