Imetec SUPERPLATE COMPACT, Operating Instructions Manual

10

GB

Polishing function

Switch the polishing function on by setting the ON/OFF switch (5) to position I 

[Fig. E1]

. To switch the 

function off, set the ON/OFF switch (5) to position 0. 

Vacuum cleaner function

Switch off the appliance and remove the polishing head (11) by pressing the polishing head release button 
(10). Install the combined brush, and turn

on the vacuum cleaner function by setting the ON/OFF switch (5) 

to position II.

After 

fi

 nishing your work, switch off the appliance by setting the ON/OFF switch (5) to position 0 and pull the 

power plug out of the socket.

Rewind the main power cable (7) on the winding hooks (6).

MAINTENANCE

Before opening the appliance, switch it off and pull the power plug from the socket! Before using the 
appliance again, make certain that all parts cleaned with liquid are completely dry!

Cleaning the appliance:

Clean the appliance as needed with a damp cloth. Do not use solvents or other aggressive or sharp-edged 
cleaning aids. These could damage the surface.

Cleaning the brush set (12):

You can wash the brush set (12) with warm water using a neutral detergent. The felt (12A) and wool felt 
brushes (12D) can be cleaned by rubbing them gently with a damp cloth. Let the brush set (12) dry thoroughly, 
making sure that they stay in horizontal position.

Cleaning the combination brush (13):

With the motor switched on, run your hand over the brush to loosen clinging dust and lint which will be 
directly vacuum cleaned.

Cleaning the dust collection system (9):

Remove the collected dust from the appliance when the vacuum cleaner suction power is decreased. The 
dust container can be 

fi

 lled up to the marking (9F) indicated in the dust collection system (9).

Note:
It is strongly recommended that the dust collection system (9) is emptied and the 

fi

 lters cleaned after 

every use.

If the power of your vacuum does not improve after cleaning the dust collection system (9), this could result 
from the 

fi

 lters in the appliance being very dirty. In this case, the 

fi

 lters must be replaced. To do so, follow the 

instructions on the image symbol  .