13
Declaration: The structures of
PG-2SA/PG-2SF/PG-2SC/PG-2SD/PG-2MA/PG-2MB/PG-2MC/PG-2MD are different, the
differences are: The upper and lower module plate of PG-2SA and PG-2MA are ribbed; the
upper and lower module plate of PG-2SF and PG-2MB are smooth. The upper and lower module
plate of PG-2SC and PG-2MC are upper ribbed and lower smooth. The upper and lower module
plate of PG-2SD and PG-2MD is upper smooth and lower ribbed.
1. HEATING INDICATOR
2.TEMPERATURE CONTROLLER
3.CROSS-HEADED SCREW M4×6
4. POWER INDICATOR
5. BOTTOM HULL
6. INTERNAL HEXAGON SCREW M6×10
7. FLAT SPACER
8. INTERMAL HEXAGON SCREW M5×25
9. FLAT SPACER
10. WISTING SPRING
11. REAR ROTARY AXLE
12. FASTONTING STAND
13. INTERNAL HEXAGON SCREW
M6×40
14. BACK UPPER COVERING BOARD
15. SCROSS-HEADED SCREW M4×8
16. SPRING PIN
17. EQUIPOTENTIAL GROUND SCREW
M6×15
18. POWER SUPPLY WIRE JACKET
19. POWER CORD
20. POWER GROUND SCREW M5×15
21. GRILL OF LOWER MODULE
22. UPPER MODULE BOARD
23. CROSS-HEADED SCREW M4×8
24.
HEAT-INSULATED
COTTON
OF
UPPER MODULE
25. PLATEN OF UPPER ELECTRIC
HEATING TUBE
26. GRILL OF UPPER MODULE
27. ELECTRIC HEATING TUBE OF
UPPER MODULE
28. INCOMING LINE TUBE
29. SPRING CHECK RING FOR AXLE
30. SPRING CHECK RING FOR TUBE
31. AXLE OF UPPER MODULE
32.
INTERNAL
HEXAGON
SCREW
M5×16
33. INTERNAL HEXAGON SCREW M6×8
34. HANDLE
35. FRAME OF OPERATION HANDLE
36. OIL TRAY 37. HALF OF CHEESE
HEAD SCREW M6×12
37. HALF OF CHEESE HEAD SCREW
M6×12
38. SMALL BALL
39.
HEAT-INSULATED
COTTON
OF
LOWER MODULE
40. PRESSURE PLATE FOR COTTON
41. CROSS-HEADED SCREW M4×20
42. AMPHENOL CONNECTOR PLATE
43. CROSS-HEADED SCREW M4×8 44. CERMIC CONNECTORS
45. TEMPERATURE LIMITER
46. HEXAGON SCREW M6×20
47. RUBBER FOOT
48.
PRESSURE
PLATE
FOR
ELECTRIC HEATING TUBE OF LOWER
MODULE
49. ELECTRIC HEATING TUBE OF
LOWER MODULE
50. INTERNAL HEXAGON SCREW M6×8
51. BOTTOM BOARD
52. CROSS-HEDED SCREW M4×8
