09 EVO Junior –
IM.EX.SERVE s.r.l. Italy
When you press the button (10 – see cap. 5) on the handle you will hear the pump of the
detergent starting to work. Depending on the settings, it will work intermittently or continuously.
To switch off the detergent function press button (5) on the appliance panel and the display will
show C.oFF
It is possible to regulate the quantity of water in the steam using the button (5) on the appliance
panel as follows:
1) Press once to active the detergent function
2) Keep it pressed for 2-3 seconds till the display shows the number of the water quantity level
preset. Release the button.
3). Press the button (4) again and keep it pressed to change the level.
4) Once the desired level is selected, release the button and press it once again to confirm the
setting.
5)
Now the detergent quantity has been set.
The functions Steam and Chemical can be used simultaneously.
4.6 Steam Vacuum
The Steam Vacuum function, with the vacuum kit (Model VC-09), is activated by placing the
suction unit (VC09) over the 09EV0 and connecting its plug to the Schuko socket on the back of
the steam generator.
Then, connect the Steam Vacuum hose connector to the generator and the suction hose to the
vacuum.
Turn on the main switch at head of the vacuum and press the button 12 (see Article 5.3) on the
hose.
Holding down the button on the handle 12 can change the speed of aspiration from min to max.
This device is not suitable for vacuuming hazardous dust.
4,7 Eco Power
The Eco Power has been designed to enable the use of the device with an energy saving
.
Activating this function, the unit will operate normally in all its functions with a lower absorption
of Watts (about 1200 Watts savings
).
Depending on the type of the application that you need
to do, it would be convenient to activate
the Eco Power.
The activation of the Eco Power will also allow the use of the appliance in environments where
the maximum load of the civil power outlets can not exceed 3kW.
28/36
