- 6 -
5. Laser Accuracy
General
The Imex 66R is calibrated at point of manufacture
and re checked prior to despatch to ±2mm/ 30m.
It is the responsibility of the user to follow operating
instructions and to periodically check the accuracy of the
laser. If your 66R requires adjustment then please contact
your nearest dealer
5.1 Checking the accuracy
Accuracy check
steps
The 66R is within accuracy if the four marks are within 2mm
from the centre (4mm max extreme edges) at 30m
Step Description
1.
30m
Place the i66R on a flat, level surface or
tripod approximately 30m from a wall.
2.
Align the first axis so that it is square to the wall. Allow the 66R to
self- level completely and it will begin to rotate.
3.
Mark the position of the beam on the wall. (centre of the point)
4.
Very carefully rotate the laser on the tripod 180° and allow it to
rotate and self-level.
5.
Mark the position of the beam on the wall. (centre of the point) if
different from the original mark.
6.
Align the second axis so it is flat to the wall by carefully rotating the
laser on the tripod by 90°. Allow the 66R to self-level completely.
7.
Mark the position of the beam on the wall. (centre of the point) if
different from the previous marks.
8.
Very carefully rotate the laser on the tripod 180° and allow it to
rotate and self level.
9.
Mark the position of the beam on the wall. (centre of the point) if
different from the previous marks.
