Page | 7
2.8 Vertical Mode
Description of
Vertical Mode
The Vertical mode allows the laser to be laid on it’s back so the
laser can produce a vertical plumb laser plane, which can be
used to for vertical alignment of form work, pipe lines, stud walls
etc.
Vertical mode
Ste-up
Place the i88R/G on its back on a floor or board, or mount
alternatively on a tripod on the rear laser mount point.
Turn the i88R/G on and allow the laser to self-level
Once laser has self-levelled, all functions that can be carried
out in horizontal mode can be carried out in vertical mode
3. Detector
3.1 LRX10 Detector –
Refer to page 5, LRX10 Manual and www.imexlasers.com.au
4. Battery
General
The i77R is supplied with a 9Ah 3.7 v Li-ion battery with USB-
C fast charge capability, a full battery has approximately 40
hours run time. The battery can be charged in the unit by
plugging the charger chord into the USB-C port on the front to
the laser or out the unit, by plugging the charging chord directly
into the USB-C port on the battery.
Charging
Please charge the battery prior to use. Full battery charge time is
approx. 3.5 hours
The charging temperature range is between 0°C and +40°C
The battery may feel warm whilst charging.
Please only charge with the Imex chargers supplied with the unit.
When battery is charging, red battery charging indicator light will
light, when battery is fully charged green indicator light will light.
Battery Placement
When putting battery into the laser unit, please ensure
correct polarity of terminals. If battery is incorrectly inserted into
the laser level the battery will lock to prevent damage to the
laser and battery.
To unlock/re-set battery, insert battery into the laser with
correct polarity and charge for 5 minutes, the battery will then
re-set and return to previous charge level.
