65
de
fr
en
nl
Start-up
Water make-up
• Possible settings:
A B C D
Automatic water make-up
þ þ þ
External make-up signal
þ þ
Through RS 485-1
þ
Selection A:
Automatic water make-up is deactivated.
Selection B:
Automatic water make-up is activated, integrated
PIS pressure sensor determines the switching points.
Selection C:
Automatic water make-up is activated, external
make-up signal LSext on DEC (
:
page 63) determines the
switching points.
Selection D:
Automatic water make-up is activated, external
make-up signal LSext through the RS 485-1 interface (
:
pages
61 | 63) determines the switching points.
IBN complete
• The system can only go into operation after all start-up steps
have been completed and confirmed.
standby
or
auto
•
standby
: Select this if Pleno PI is not to go into operation yet,
but the display function is to remain active.
•
auto
: Select this if all the requirements for start-up are present,
and the Pleno Pl is to go into operation.
After auto operation is started, note the following:
• Key lock is automatic after 30 min, or activate manually.
:
page 54
• When auto mode is started, the analogue pressure indication must be visible on the display.
This appears only in the range from
min
(P0) to
max
(PSV).
:
page 55
Start-up is now complete. Pleno Pl works automatically.
• To prevent unauthorised access, the
Start-up menu
can be permanently hidden.
:
page 56
Start-up
Summary of Contents for IMI PNEUMATEX Pleno PI
Page 1: ...WPMOIN0002 02 2019 Pleno PI...
Page 99: ......
