Echo
®
Wireless Vibration Sensor Manual
Version 1.2, 2011-12-07
3
FCC NOTICE
FCC ID: ZOC-IMI670A01
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
INDUSTRY CANADA (IC) NOTICE
IC: 9732A-IMI670A01
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
HAZARDOUS AREA USE
Warning- Explosion Hazard- Do Not Disconnect or connect while circuit is live unless
area is known to be non-hazardous. Batteries must not be changed unless area is known
to be Non-Hazardous. Do not open when an explosive atmosphere may be present.
Substitution of components may impair suitability for Class I, Div 2.
Advertissment- Risque D’explosion – Ne pas debrancher ou brancher tant que le
circuitest sous tension. A moins qu’il ne s’agisse d’un emplacement non dangereux. Les
piles ne doivent pas etre remplacees a moins qu’il ne s’agisse d’un emplacement non
dangereux. N'ouvrez pas lorsqu'une atmosphère explosive peut être présente.
Remplacement de composants peut nuire à la conformité de Classe I Div 2.
