13
Instructions for the installer
3
INSTRUCTIONS FOR
INSTALLATION
3.1 GENERAL RECOMMENDATIONS
ATTENTION!
This boiler must only be employed for its explicitly
intended use. Any other use must be considered
improper and therefore dangerous.
This boiler is used to heat water to below boiling
temperature in atmospheric pressure.
ATTENTION!
These appliances are designed exclusively for
installation inside suitable technical compartments.
Before connecting the boiler, have professionally
authorised company:
a) Accurately washing all of the pipes in the system
to remove any residues or sediments could stop
the boiler form running efficiently, even in terms
of health and hygiene.
b) Making sure the boiler is set up to operate with the
available type of fuel. The type of fuel is stated on the
packaging and technical characteristics plate.
c) Make sure that the chimney/flue has an adequate
draught, that it is not choked, and that there are no
other exhausts for other appliances, unless the flue
is designed for multiple utilities, in accordance with
standard specifications and requirements in force.
Only once this check has been carried out can the
fitting between boiler and chimney/flue be set up.
ATTENTION!
In rooms with aggressive vapour or dust, the
appliance must operate independently of the air in
the room of installation!
ATTENTION!
The appliance must be installed by an authorised
company possessing professional-technical
qualifications in accordance with the law, who, under
his/her own responsibility, enforces the observance of
regulations according to the rules of good practice.
ATTENTION!
Assemble the appliance in observance of the minimum
required distances for installation and maintenance.
The boiler must be connected to a heating system
compatibly with its specifications and power.
