4
General information
INFORMATION:
this symbol is used to highlight important information for proper boiler operation. Failure to comply with the
provisions will compromise use of the boiler and operation will be unsatisfactory.
ATTENTION:
this warning symbol located in various points of this booklet indicates that the message it refers to must be
read carefully and understood, since failure to follow what is written can cause serious damage to the boiler and
endanger the user.
Dear Customer,
whilst thanking you for purchasing one of our boilers, we would like to remind you that pellet boilers are the most
innovative central heating solution that is the result of highly advanced technology with top quality processing and a simple and
elegant design that is adapted to any technical room, making the environment cosy that is only obtained by the welcoming heat
of a flame.
The boilers, which operate exclusively with wood pellets having a maximum diameter of 6mm, are equipped with a vertical pipe
heat exchanger.
The boilers convey heat to your system with thermal power that is adjusted according to the technical room to heat: just manually
set the water temperature of the central heating system, recommended 65 °C - 70 °C.
The boilers have been provided with sophisticated automatisms and control and safety systems that guarantee efficient and prac-
tical operation.
During first ignitions of the boiler, the vapours emitted by the paint may cause a bad smell due to hardening. Therefore, it is ad-
visable to air the room well in order to prevent prolonged persistence in front of the boiler.
IT IS prohibited to install the appliance in bedrooms or areas having explosive environments.
Installation and maintenance must be carried out by qualified
staff in compliance with the laws in force in this regard and
pursuant to the instructions of the Manufacturer.
The Manufacturer shall not be held liable in any way should in-
stallation be carried out by unqualified people and for failure to
comply with the general warnings and installation instructions.
This manual is an integral part of the product: make sure it
always accompanies the appliance, even if it is transferred to a
new owner or user or the boiler is transferred to a new place. If
it is lost, please ask the manufacturer for another copy.
Before installing, using and carrying out maintenance on the
product, you must read these instructions carefully.
The technical installer must provide you with the relative in-
structions before proceeding with first ignition.
This boiler must only be used for its explicitly intended use.
Therefore, all liability for any harm to people and/or animals
or damage to property caused by improper use of the product
will be borne by the user.
The entire range of products is manufactured according to the
following directives and regulations:
2014/30 EU (EMCD Directive), 2006/42/EC, 2014/35 EU (Low
Voltage Directive), 2011/65/EU; EN 61000-6-2; EN 61000-6-3;
EN 60335-1; EN 60335-2-102; EN 62233; EN 50581; EN 303:5-
2012
After removing the packaging, make sure the contents are in-
tact and complete. Should there be a discrepancy, contact your
boiler’s dealer.
Before installing the appliance, it is recommended to wash the
system’s pipes accurately in order to remove any residues that
could stop the appliance from running efficiently.
It the boiler is not used for long periods of time, it is recom-
mended to do the following:
- disconnect the plug from the mains power supply
- close the heat system and DHW water valves
- if there is a risk of freezing, empty the heating and DHW
system.
