52
INS
TALLER
U
SER
M
AINTEN
AN
CE
TECHNI
CI
AN
TECHNI
CAL
D
AT
A
3.9 P.C.B. PROGRAMMING
The boiler is prepared for possible programming of several opera-
tion parameters.
By modifying these parameters as described below, the boiler can
be adapted according to specific needs.
To access the programming phase, proceed as described below
(Parag 2.3):
- press buttons (
) and (
) for 5 about seconds until the
programming mode is accessed on the display;
- using buttons ( ) and ( ), select the parameter to be changed
indicated in the following table;
- adjust the corresponding value consulting the table using but-
tons ( ) and ( );
- confirm the value set by pressing the button (
) for about 5
seconds.
2 minutes after no button is touched will automatically
cancel the operation or by pressing buttons
(
) and (
) simultaneously for about 5 se-
conds.
