1.21 HYDRAULIC DIAGRAM CON OPTIONAL.
Key:
1 - Victrix 115 1 I boiler
2 - Manometer pocket
3 - Probe for fuel shut-off valve bulb
4 - Manometer-holder cock
5 - Thermometer
6 - Manual rearm thermostat
7 - Manual rearm pressure switch
8 - Boiler connection 3-way valve
9 - Hydraulic manifold/mixer
10 - Attachment for expansion vessel
11 - Expansion vessel
12 - Fuel shut-off valve
13 - Slurry collection brass filter
14 - Damper coil
15 - Manometer
Important:
the sensitive elements of the automa-
tic regulation and block circuit breaker switches
and of the thermometer (not supplied as standard
with the boiler) must be set/up as described in the
installation instructions. Whenever the genera-
tors are not installed in battery according to the
instructions and the Immergas original kit, the
sensitive elements must be installed on the flow
piping to the central heating system, immersed in
the current of water at not more than 0.5 metres
from the boiler outlet.
the boilers must be installed in the configurations
and with their own Immergas original battery
and safety kits. Immergas S.p.a. declines all
liability whenever the installer does not use the
devices and Immergas original kits or uses them
improperly.
Fig. 1-26
126
TR
SI
RU
IE
CZ
