Immergas VICTRIX 24 TT 1E, Instruction And Warning Book

SI

NO

1-1

5

INS

TALLER

US

ER

MAINTEN

AN

CE TECHNI

CI

AN

1

 BOILER  

INSTALLATION

1.1 INSTALLATION 

RECOMMENDATIONS.

The Victrix TT boiler has been designed for 

wall mounted installation only; for heating and 

production of domestic hot water for domestic 

use and similar purposes.

The place of installation of the appliance and 

relative Immergas accessories must have suitable 

features (technical and structural) such to allow 

(always in safety, efficiency and comfortable 

conditions):

-  installation (according to the provisions of the 

technical legislation and technical regulations);

-  maintenance operations (including scheduled, 

periodic, routine and special maintenance);

- removal (to outdoors in the place for loading 

and transporting the appliances and compo-

nents) as well as their eventual replacement 

with appliances and/or equivalent components.

The wall surface must be smooth, without any 

protrusions or recesses enabling access to the 

rear part. They are not designed to be installed 

on plinths or floors (Fig. 1-1).

By varying the type of installation the classifica-

tion of the boiler also varies, precisely:
- 

Type B

23

 or B

53

 boiler if installed using the 

relevant terminal for air intake directly from 

the room in which the boiler has been installed.

- 

Type C boiler

 if installed using concentric 

pipes or other types of pipes envisioned for 

sealed chamber boilers for air intake and ex-

pulsion of flue gas.

Only professionally enabled companies are 

authorised to install Immergas gas appliances.

Installation must be carried out according to 

regulation standards, current legislation and in 

compliance with local technical regulations and 

the required technical procedures.

Attention: 

the manufacturer declines all liability 

for damages caused by boilers removed from 

other systems or for any non-conformities of 

such equipment.
Before installing the appliance, ensure that it is 

delivered in perfect condition; if in doubt, contact 

the supplier immediately. Packing materials (sta-

ples, nails, plastic bags, polystyrene foam, etc.) 

constitute a hazard and must be kept out of the 

reach of children. If the appliance is installed in-

side or between cabinets, ensure sufficient space 

for normal servicing; therefore it is advisable to 

leave clearance of at least 3 cm between the boiler 

casing and the vertical sides of the cabinet. Leave 

adequate space above the boiler for possible water 

and flue removal connections. Keep all flamma-

ble objects away from the appliance (paper, rags, 

plastic, polystyrene, etc.).

Do not place household appliances underneath 

the boiler as they could be damaged if the safety 

valve intervenes, if the drain trap is blocked, or 

if there are leaks from the hydraulic connec-

tions; otherwise, the manufacturer cannot be 

held responsible for any damage caused to the 

household appliances.

For the aforementioned reasons, we recommend 

not placing furnishings, furniture, etc. under 

the boiler. 

In the event of malfunctions, faults or incorrect 

operation, turn the appliance off immediately and 

contact an authorised company (e.g. Technical 

Assistance centre, which has specifically trained 

staff and original spare parts). Do not attempt to 

modify or repair the appliance alone.

Failure to comply with the above implies personal 

responsibility and invalidates the warranty.
• Installation regulations: 
  - this boiler can be installed outdoors in a 

partially protected area. A partially protect-

ed area is one in which the appliance is not 

exposed to the direct action of the weather 

(rain, snow, hail, etc..).

NOTE: 

this type of installation is only possible 

when permitted by the laws in force in the 

appliance’s country of destination.

  - Installation of gas appliances, flue exhaust 

pipes and combustion air intake pipes is 

forbidden in places with a fire risk (for ex-

ample: garages, closed parking stalls), and 

in potentially dangerous places.

  - Installation is prohibited on the vertical 

projection of cooking hobs.

  - Installation is forbidden in places/rooms 

that constitute public areas of apartment 

buildings, internal stairways or other escape 

routes (e.g. floor landings, entrance halls, 

etc.).

  -  Installation is also forbidden in places/rooms 

that constitute public areas of apartment 

buildings such as cellars, entrance halls, attics, 

lofts, etc., unless otherwise provided for by 

local regulations in force.

Attention:

 wall mounting of the boiler must 

guarantee stable and efficient support for the 

generator.

The plugs (standard supply) are only to be used 

to fix the appliance to the wall;

 they only ensure 

adequate support if inserted correctly (according 

to technical standards) in walls made of solid or 

semi-hollow brick or block. In the case of walls 

made from hollow brick or block, partitions with 

limited static properties, or in any case walls 

other than those indicated, a static test must be 

carried out to ensure adequate support.
These boilers are used to heat water to below 

boiling temperature in atmospheric pressure.

They must be connected to a central heating 

system and hot water circuit suited to their 

performance and capacity.

YES

NO