20
STVZSkW ed 09/08
VICTRIX ZEUS Superior kW I
Technical Documentation
Technical Documentation
Intake and exhaust systems.
(see intake and exhaust terminals instructions).
The VICTRIX ZEUS Superior kW I boiler is prepared for
connection to the appropriate snap-fit intake/exhaust pipes
and can be installed inside the home or outside the home
or outside of the home (in a partially protected place) in the
following configurations:
Outdoor (in partially protected place):
- with sealed chamber and fan-assisted circulation with direct
intake using an appropriate top cover kit (optional) manda-
tory;
- with sealed chamber and fan-assisted circulation (type C)
using the vertical or horizontal concentric kits, keeping the
lateral plugs without the obligation to use the top cover
kit.
Indoor:
- open chamber and fan-assisted circulation (type B
23
) using
an appropriate top cover kit (optional) mandatory;
- with sealed chamber and fan-assisted circulation (type C)
using the vertical or horizontal concentric kits or the Ø 80/80
separator kit.
For that regarding the head losses relative to each accessory,
for the various combinations that can be performed,
see the
instructions relative to the intake and exhaust terminals
(boiler instruction book).
The generators with condensation technology must be installed
using the
specific
series of intake and exhaust pipes, which
have been designed
to be coupled exclusively to the Immergas
condensing boiler.
The “
GREEN SERIES
” flue kit is made in plastic (PPS = self-
extinguishing polypropylene) suitable for resisting the corrosive
action of the acid condensate.
Configuration with sealed chamber and fan-
assisted circulation with direct intake for instal-
lation outdoors in a partially protected place
(see figure at the side).
Using a relevant cover (1) to position on the upper part of the
sealed chamber, it is possible to install the boiler outdoors in
partially protected places.
Intake.
Assembly of the cover (1) envisions the removal of the plug
(3) positioned to close the hole present in the upper part of
the sealed chamber.
Combustion air intake takes place directly from the environ-
ment, making use of the free space between the lower part of
the cover (1) and the upper part of the boiler.
Exhaust.
The 80 mm diameter exhaust pipe fitting is obtained using the
flange (2) used in the divided systems.
The use of relevant accessories allows horizontal (A) or vertical
(B) exhaust.
To prevent condensate problems, the exhaust pipe must be
limited
to 30 straight metres
Configuration with open chamber and fan-
assisted circulation (type B
23
) for indoor instal-
lation
(see figure above)
.
The previously-described cover kit is used.
By removing the plug (3) present in the upper part of the sealed
chamber, air intake takes place directly in the environment
where the boiler is installed.
Flue exhaust takes place through the specific pipes with diame-
ter of 80 in an individual flue or directly to the outside.
B
A
3
1
2
Summary of Contents for VICTRIX Superior 32 kW X
Page 2: ......
