Immergas VICTRIX ZEUS SUPERIOR, Instruction Booklet

14

C

83

1-23

C

43

1-22

1-21

1

4

7

9

5

5

6

7

8

3

2

S

A

C

53

* - C

83

INS

TALLER

US

ER

MAINTEN

AN

CE TECHNI

CI

AN

1.14 SEPARATOR KIT INSTALLATION.

Type C configuration, sealed chamber and 

fan assisted.
Separator kit Ø 80/80.

 This kit allows air to come 

in from outside the building and the fumes to exit 

from the chimney or flue through divided flue 

exhaust and air intake pipes. Combustion prod-

ucts are expelled from pipe (S) (in plastic, so as 

to resist acid condensate). Air is taken in through 

duct (A) for combustion (this is also in plastic). 

The intake pipe (A) can be installed either on the 

right or left hand side of the central exhaust pipe 

(S). Both ducts can be routed in any direction.
•  Kit assembly (Fig. 1-21): install flange (4) on the 

innermost hole of the boiler, positioning gasket 

(1) with the circular projections downwards in 

contact with the boiler flange, and tighten using 

the hex screws with flat tip supplied with the 

kit. Remove the flat flange present in the most 

external hole and replace it with the flange (3), 

positioning the gasket (2) already present in 

the boiler and tighten using the supplied self-

threading screws. Fit the male side (smooth) to 

the bends (5) in the female side of the flanges 

(3 and 4). Fit the intake terminal (6) with the 

male side (smooth) in the female side of the 

bend (5) up to the end stop, ensuring that the 

internal and external wall sealing plates are 

fitted. Fit the exhaust pipe (9) with the male 

side (smooth) to the female side of the bend 

(5) up to the end stop; making sure that the 

internal wall sealing plate has been fitted, this 

will ensure sealing and joining of the elements 

making up the kit.

• Installation clearances (Fig. 1-22). The mini-

mum installation clearance measurements of 

the Ø 80/80 separator terminal kit have been 

stated in some limit conditions.

• Extensions for separator kit Ø 80/80. The 

maximum vertical straight length (without 

bends) that can be used for Ø 80 intake and 

exhaust pipes is 41 metres, regardless from 

whether they are used for intake or exhaust. 

The maximum horizontal straight length (with 

bend in suction and in exhaust) that can be 

used for Ø 80 intake and exhaust pipes is 36 

metres, regardless from whether they are used 

for intake or exhaust.

N.B.:

 to favour the removal of possible conden-

sate forming in the exhaust pipe, tilt the pipes 

towards the boiler with a minimum slope of 

1.5% (Fig. 1-23).

The kit includes:

N° 1 -  Exhaust gasket (1)

N° 1 -  Flange seal gasket (2)

N° 1 -  Female intake flange (3)

N° 1 -  Female drain flange (4)

N° 2 -  Bend 90° Ø 80 (5)

N° 1 -  Intake terminal Ø 80 (6)

N° 2 -  Internal wall sealing plates (7)

N° 1 -  External wall sealing plate (8)

N° 1 -  Drain pipe Ø 80 (9)

  *  to er complete C

53

 configuration also provide for a roof discharge terminal.

minimum slope 1.5%