Slew Drives
Transport, packaging, and storage
18
Unpacked slew drives can be transported with lifting gear when
using eye bolts under the following conditions
The lifting gear must be configured appropriately for the
weight of the transport units.
The ring bolts must be configured appropriately for the weight
of the transport unit.
The slew drive shall only be transported by itself, without
attached parts.
Maintain the insertion depth prescribed by the manufacturer.
If insertion depth is not prescribed, then a minimum insertion
depth of 1.5 x the bolt diameter must be selected.
Transport within the company shall only be executed
horizontally.
Fig. 8: Always use the full length of the
thread
Attachment:
1.
Screw the 3 eye bolts into the 3 threads that are distributed
uniformly on the circumference of the slew drive.
WARNING!
WARNING!
WARNING!
WARNING!
Screw in the eye bolts to the full thread length!
Improperly attached, unsuitable, or damaged eye bolts
may cause the slew drive to fall and cause life-threatening
injuries.
2.
Attach lifting gear to the eye bolts.
3.
Start the transport.
4.3
Transport inspection/incoming goods inspection
Check delivery immediately upon receipt to ensure that delivery is
complete, and to identify any transport damage.
Proceed as follows if there is apparent external damage:
Do not accept the delivery, or only accept it with reservation.
Note the extent of transport damage on the transport
documents or on the transport company's delivery ticket.
Submit a complaint.
Report any defect within 2 days of delivery of goods. Claims for
damage compensation can only be enforced during this period
of notification.
