HOSE END FOAMER MODELS 481 AND 483
Package Contains:
1. Injection molded assembly: foaming barrel, handle, and
eductor.
2. Concentrate container: Model 481 - 96 oz., Model 483
- 48 oz.
3. Suction tube/strainer.
4. Spray gun with quick disconnect assembly
5. Metering tip kit.
6. Product information sheet.
THANK YOU FOR YOUR INTEREST IN OUR PRODUCTS
Please use this equipment carefully and observe all warnings and cautions.
***********************************************************************************NOTE************************************************************************************
WEAR
protective clothing and eyewear when dispensing chemicals or other materials.
ALWAYS
observe safety and handling instructions of the chemical manufacturers.
ALWAYS
direct discharge away from you or other persons or into approved containers.
ALWAYS
dispense cleaners and chemicals in accordance manufacturer’s instructions. Exercise CAUTION when maintaining your equipment.
CLEAN
equipment after each use in accordance with instruction sheet.
WEAR
protective clothing and eyewear when working in the vicinity of all chemicals, filling or emptying equipment or changing metering tips.
ALWAYS
re-assemble equipment according to instruction procedures. Be sure all components are firmly screwed or latched into position.
ATTACH
only to tap water outlets (85 PSI maximum).
Tip Color
Drill Size
Ratio
Oz/Gal
No Tip
12:1
10
Gray
30
*
*
Black
40
*
*
Beige
50
*
*
Red
55
*
*
White
57
14:1
9
Blue
60
16:1
8
Tan
65
18:1
7
Green
70
26:1
5
Orange
72
32:1
4
Brown
74
*
*
Yellow
76
42:1
3
Aqua
77
*
*
Purple
79
64:1
2
Pink
87
128:1
1
Operation:
1. Unscrew foamer lid assembly from container.
2. Select a metering tip using the chart below as a guideline and press the tip firmly into the hose barb on the bottom of the lid assembly. Install the
suction tube on the hose barb.
3. Fill the container with concentrate. Screw foamer lid assembly securely onto container.
CAUTION:
Foamer lid assembly must be securely fastened to container to prevent accidental spilling of concentrate during
use of foamer.
4. Insert foamer lid assembly into female quick to connect on spray gun.
5. Connect a garden hose with 3/4” male garden hose thread to the base of the spray gun handle. Turn on the water supply to the hose. (Minumum
25 PSI water pressure is required to operate the foamer.)
6. Grasp the spray gun handle in one hand and the foamer container in the other. Squeeze the spray gun handle to begin foaming. Continuous
operation can be achieved by using the handle lock provided on the spray gun. Rinse by disconnecting the spray gun from the foaming lid
assembly. To remove the foamer from the spray gun, simply grasp the quick connect on the spray gun in one hand and the foamer assembly in the
other. Pull in opposite directions. (The outside collar around the quick connect will slide toward the spray gun, disengaging the foamer barrel.)
Metering Tip Selection:
Dilution ratios below were achieved at 40 PSI, cold water and water-thin viscosity (1.0 CP). Ratios will vary given PSI, water and ambient temperature,
water flow rate, and product viscosity. At water-thin viscosity, the efficiency of the eductor is at its maximum with the black or gray tip. Removal of the
foot strainer on the concentrate pick-up tube will also change these ratios. *If no tip is listed, the dilution ratio delivered falls between those shown.
