4
Page 4
Page 5
10M
25M
50M
75M
100M
10Y
25Y
50Y
75Y
100Y
Next, assemble the cross bar. You can
assemble the cross bar sections into a 6, 9,
or 12-foot length. The ends of your cross
bar must be the sections with oval holes.
Connect one section to another by
inserting a knobbed end into an open end.
Twist the two sections until you can insert
the knobbed end all the way.
5
6
Twist until the flat indents align. This
locks the pieces. Continue adding
sections in this way, keeping the sections
with the oval holes on the two ends.
Mount the cross bar onto the spigots.
You may need to adjust the position of the
stands. Make certain the support system
is steady and in position before adding
backdrops.
7
8
Your Impact Background Support System
will now support a cloth or seamless paper
background.
For a cloth background, you’ll have to first
remove the cross bar. Slide the cross bar
into the pocket on top of the background.
Then remount the cross bar.
9
10
If you’re using seamless paper as your
background, lift one end of your crossbar
from its support stand. Slide the paper
roll over the crossbar, then remount the
cross bar.
Pull down the paper roll to the desired
length. Secure the seamless paper roll
with clamps or gaffers’ tape to prevent it
from unrolling.
11
12
