Setting Up Your Umbrella-Mount Bracket
Page 8
Page 5
The Standard and Deluxe Umbrella-Mount brackets are very similar, but we’ll show how
to set up both models in this guide. Begin by loosening the locking knob. Remove the
brass mounting stud adapter. Even if you don’t need this stud adapter for your current
setup, don’t lose it. You may need it in the future.
1
If your light stand has a standard 5/8˝ stud on top, mount your bracket on the stud and
tighten the locking knob.
2
To mount a small light fixture, unscrew and remove the cold shoe. Mount the light using
the exposed 1/4˝ screw. Or turn this fitting around for the 3/8˝ screw. If you need a 5/8˝
stud fitting, connect the two brass fitting adapters. This gives you a standard 5/8˝ stud
fitting that most lights use.
7
8
The umbrella socket slopes upwards slightly to give your flash better beam spread into
your umbrella. Insert the umbrella shaft into the high end of the umbrella socket and
tighten the thumbscrew. Don’t over-tighten, to avoid pinching the umbrella shaft.
Umbrellas larger than 45˝ are not recommended for use with these brackets.
or
or
10
M
25M
50
M
75
M
10
0M
10
Y
25Y
50
Y
75
Y
10
0Y
DO NOT EDIT OR REVISE ARTWORK
We will not approve any artwork which has been altered by the vendor
FORWARD YOUR PROOFS
to mabel.li@asia.bhphotovideo.com
FOR APPROVAL BEFORE FINAL PRODUCTION
DO NOT BEGIN PRODUCTION WITHOUT PRIOR APPROVAL OF PROOFS
