B
ATTERY
C
HARGING
Set-Up
1. Plug the charging and LiPo balance
cables into the charger.
2. Attach a batteries to the Channels 1-4
cable sets. Both cables from a single
channel must be connected to the same
battery.
3. Plug the Charger into a 110V outlet with
the included power cord.
Charging
1. Verify that
LiPo
Charge, 7.0A,
and
22.2V(6S) are displayed as shown. If not,
refer to the charger user manual to
change
the
settings.
The
red
LED
indicates the current channel.
2. Long press START. The charger will
perform a battery check.
3. When prompted, short press ENTER to
initiate charging.
4. Press CHANNEL to switch to the next
battery and repeat Steps 2 and 3 to
initiate charging.
5. Repeat Step 4 until all 4 batteries are
charging simultaneously.
6. The charger will Beep as each battery
becomes fully charged.
Controller -
The controller is charged via the micro USB port on the bottom of the unit.
Pressing the Home button displays charging progress.
5
