A
IRCRAFT
A
SSEMBLY
(C
ONT
.)
Batteries
1. Center two (2) batteries between the
straps on each side of the battery
tray with the battery cables toward
the rear of the aircraft.
2. Align the front faces of the batteries
to the front edge of the battery tray
to ensure maximum support and to
maintain
the
aircraft’s center of
balance.
3. Secure the four (4) Velcro straps by
threading the outer straps through
the buckles on the inner straps,
pulling tight, and securing the Velcro.
4. DO NOT PLUG THE BATTERIES
INTO THE BATTERY CABLES AT
THIS TIME.
Arms & Blades
1. Rotate each arm upward until it locks in
the horizontal position.
2. Remove the red blade retention clips and
straighten the propellers as shown.
ALIGN
7
Inspection
Inspect all wires, screws and connectors for proper installation, tightness, and wear.
Do not
over-tighten screws. Snug plus 1/4 turn is recommended.
Note:
The sUAS is shipped with three unconnected auxiliary power cables for future use. The
two 5V and one 12V cables are located next to the forward-facing FPV camera. There is also an
unconnected winch connection cable on the bottom of the airframe.
