IMPACT SUBSEA
INNOVATIVE UNDERWATER PRODUCTS
www.impactsubsea.com
Document No:
0000.1991 |
Version No:
1.6 | 6
th
October 2020
22
Orientation & Magnetic Calibration:
Shown above: ISS360 Orientation Settings
In this window the orientation of the sonar can be defined.
Note:
It is standard to have the boot end of the sonar orientated upwards (with the connector
downwards). If the boot end of the sonar is facing downwards (with the connector
upwards) this is considered to be inverted – in which case the
‘Sonar is Inverted’
box should
be checked.
If the sonar is installed on its side, the
‘Pitch/Roll from horizontal’
box should be checked.
If the optional AHRS is installed, offsets can be entered here.
Once configured, clicking the OK tick button will save the settings to the sonar firmware.
A magnetic calibration can be conducted to ensure accurate heading readings by clicking
‘Calibrate AHRS’