ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: One Adjustable Wrench and Allen Wrench
NOTE: It is strongly recommended this machine be assembled by two or more people to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Left Stabilizer (#3) to the Left Upright Beam (#1). Secure the side with two M10 x
3 ½” Allen Bolts (#13), four
∅
¾” Washers (#9), and two M10 Aircraft Nuts (#14). Secure the
Bottom with one M10 x 5/8” Allen Bolt (#10) and Ø ¾” Washer (#9). Do NOT tighten all the
Nuts and Bolts yet.
B.) Repeat the above procedure A to Connect the Right Stabilizer (#4) to the Right Upright Beam
(#2).
DIAGRAM 1
5
Summary of Contents for APEX DBR 92
Page 5: ...HARDWARE PACK 4 ...
Page 9: ...8 ...
