Impex IGS-8861, Owner'S Manual

STEP 4   (See Diagram 4) 

A.) Insert two M10 x 2 3/8” Carriage Bolts (#56) all the way through the holes on the Leg 

Developer Holder (#5), then insert the two Bolts through the holes on the Main Seat 
Support (#4). Attach the Leg Developer Holder to the Main Seat Support. Secure them with 
the two M10 x 2 3/8” Carriage Bolts, one 4 ¾” x 2” Bracket (#45), two Ø ¾” Washers (#64), 
and two M10 Aircraft Nuts (#67). Thread a M18 x Ø 5/8” Lock Knob (#47) into the nut on 
the Leg Developer Holder. 

B.) Attach the Leg Developer (#13) to the Leg Developer Holder. Secure it with one M10 x 3 

½” Allen Bolt (#57), two 

∅

 ¾” Washers (#64), and one M10 Aircraft Nut (#67).   

C.) Insert two Foam Tubes (#18) halfway through the holes on the Leg Developer. Push four 

Foam Rolls (#37) onto the Tubes from both ends.  Plug four Foam Roll End Caps (#43) 
into the ends.  

D.) Slide an Olympic Sleeve (#44) onto the weight post on the Leg Developer. Attach a Spring 

Clip (#48) to the Sleeve. 

E.) Attach the Arm Curl Handle (#30) to the back holes on the Leg Developer. Secure it with 

one 3” Lock Pin (#35). Attach the Abdominal Strap (#31) to the front holes on the Leg 
Developer. Secure it with another 3” Lock Pin.  

DIAGRAM 4 

9