STEP 3 (See Diagram 3)
A.) Attach the side-holes on the Backrest Supports (#8) to the long pivot on the Main Seat
Support. Place the Backrest Board (#11) onto the Backrest Supports. Secure it with four
M6 x 1 3/8” Hex Bolts (#41) and Ø ½” Washers (#45). Place the other end of Backrest
Board rest against the backrest Adjustment Bar.
B.) Attach the Seat Bracket (#9) to the short pivot on Main Seat Support. Secure it with one
M10 x 4 ¾” Allen Bolt (#38), two Ø ¾” Washers (#43), and one M10 Aircraft Nut (#46).
C.) Place the Seat (#12) onto the Seat Bracket. Secure it with four M6 x 5/8” Hex Bolts (#42)
and Ø ½” Washers (#45).
D.) Use a 4” L-shaped Pin (#35) to secure the Seat inclined position.
E.) Attach the Arm Curl Pad (#13) to the Arm Curl Stand (#10). Secure it with two M8 x 5/8”
Allen Bolts (#40) and Ø 5/8” Washers (#44). Insert the Arm Curl Stand into the top
opening on the Front Stabilizer. Use a Lock Knob (#20) to secure the Arm Curl Stand at
desired height.
DIAGRAM 3
6
Summary of Contents for MARCY MWB 716
Page 4: ...HARDWARE PACK 3...
Page 9: ...8...
