Impex MARCY MWM-7150, Owner'S Manual

STEP 2    (See Diagram 2) 

A.) Attach the Vertical Frame (#2) onto the Main Frame (#1). Secure them with two M10 x 2 ¾” 

Carriage Bolts (#46), one 5 ½” x 2” Bracket (#12), two Ø ¾” Washers (#59), and two M10 
Aircraft Nuts (#56). 

B.) Slide 14 Weight Plates (#40) onto the Guide Rods (#10). Make sure the deep grooves on the 

Plates all face down and toward to the back of the machine. Insert a Selector Rod (#9) into 
the center hole on the Plates. Slide the Selector Stem (#39) onto the Guide Rods. Use the 
Weight Selector Pin (#38) to select the number of Wight Pates to exercise. Please refer to 
the Weight Resistance Chart in page-19. 

C.) Attach the Upper Frame (#3) in between the two Guide Rods. Secure each Guide Rod to 

Upper Frame with one M10 x 1 ¾” Allen Bolt (#54) and Ø ¾” x Ø ½” Curved Washer (#61). 

D.) Place the Upper Frame onto the Vertical Frame. Secure it with two M10 x 2 ¾” Carriage 

Bolts (#46), one 5 ½” x 2” Bracket (#12), two 

∅

 ¾” Washers (#59), and two M10 Aircraft 

Nuts (#56). 

E.) 

Securely tighten all Nuts and Bolts installed in Step-1 and Step-2.

F.) Attach the Leg Developer (#7) to the Front Post (#6). Secure it with one M12 x 3 1/8” Allen 

Bolt (#49), two Ø 1” Washers (#60), and one M12 Aircraft Nut (#57). 

9