ASSEMBLY INSTRUCTION
Tools Required For Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended for two or more people to assemble this
machine to avoid possible injury.
STEP 1
(See Diagram 1)
A.)
Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach an Upright Beam (#1) onto a Rear Base Frame (#2). Secure them together with
two M10 x 3 ¾”
Carriage Bolts (#35), one 5 ½” Curved Bracket (#13), two Ø ¾” Washer
(#43), and two M10 Aircraft Nuts (#46) from bottom. Repeat the same step to install the
other Upright Beam onto the other Rear Base Frame.
C.) Connect the two Upright Beams with a Cross Brace (#3) in the mid-span. Secure each
end to an Upright Beam with two M10 x 3 ¾” Allen Bolts (#37), two Ø ¾” Washer (#43),
and one 3 ½” Curved Bracket (#14).
D.) Securely tighten all Nuts and Bolts.
E.) Insert two Crutches (#4) into the two Upright Beams. Insert two M18 Lock Knobs (#22)
through the selected holes to obtain desired height.
DIAGRAM 1
6
Summary of Contents for MD-860
Page 12: ...11 ...
